[color:"#23D478"]Skill and Experience Points section - other stuff[/color]

Once you find the right place to edit your experience and skill points, there is more stuff you can change. I have not done a screenshot for this, but you can see some of these values for the hero in the screenshot in the original post (though not highlighted / noted, and some covered by text).


Hex edit the data.000 file, and search for the hex series;
[color:"orange"]44 65 61 74 68 6B 6E 69 67 68 74 00 23[/color]

You can enter most of this in text, then add the [color:"orange"]00 23[/color] in hex; the first part is "Deathknight" and the next two symbols look like (but are not) a space and '#' sign, ie
[color:"#8CADFF"]Deathknight #[/color]

There will be several instances of this. Keep searching until you find the last one (there will be no 'Red' or 'Black' in front of it, and it should have a block of square and other symbols in the 2 rows above it.


Starting 11 rows below the 'D' in 'Deathknight' there is a series of data values for primary stats, some secondary stats and resistances. Each value is 3 bytes, and is separated from the next value by a single '00' byte. As with skill and experience points, the hex number pairs are listed in reverse order; most or all of these values will be low enough to only use a single byte (ie 255 or less).

The values for the primary and secondary stats represent the base values, so depending on your equipment or skill bonuses, will probably be a little less than what is shown in the characters' stat lists. Resistance levels are capped, so entering a value higher than the cap is not going to help.

In order, the values correspond to the following;
Strength, Agility, Intelligence, Speed, Survival, Constitution, Luck, Regeneration, Fire Resistance, Earth Resistance, Water Resistance, Air Resistance, Poison Resistance, Spiritual Resistance, Ethereal Resistance, Armour vs Piercing, Armour vs Crushing, Armour vs Slashing, Bone Resistance, Shadow Resistance.



From here search backwards in the data.000 file for the first instance of the hex series;
[color:"orange"]42 61 73 65 00 23[/color]

This looks like [color:"#8CADFF"]Base #[/color] (you can also just do a text search for 'Base'). The appropriate spot should only be a couple 'pages' above the Death Knight's values (though it will be more if there is a summoning doll active).

The data series for the hero starts 11 rows down from the 'B' in 'Base', and 7 bytes to the left.


Specifically for Luck, the Deathknight's value is listed 12 rows below the 'g' in 'Deathknight' while the hero's value is 12 rows below the 'a' in 'Base'.


I tried changing some of the data values before and after this section, but did not find any other changes in the stats window. There may be base values stored somewhere for the other secondary stats, but I didn't make any further attempts to find them.