Larian Studios Forums Baldur's Gate III Baldur's Gate III - Help Tips & Tricks Issues with Grym Forge

I went to grymforge, found the easy mithril(no mobs), picked up a bunch of molds, beat Boss and created a shield. Ejected the shield mold , got second mithril from place where lots of mobs spawn, put in splint mold, put on mithril and everything is stuck now. Took stuff off, slammed the forge a couple of times , as i had to do that initially to free up the lava flow. No luck. Any ideas what i am doing wrong, Tried shutting down and restarting, didnt work.

thanks in advance



ps...is there any more mithril ore other than the two deposits?

As things are stuck, you sometimes can go into turn-based mode and advance it two rounds. This can sometimes resolve things.

Hope this helps,

Ambrose Le’Fey

PS: there is only two nodes of mithril. (edit)

Will give it a try, thanks

Nope no luck, kinda sucks as i was hoping to see what two pieces of adamantine could do. Oh well, perhaps they will address this issue

Thanks for your help

For that to happen, it must first be a known issue.

You wrote about initially freeing the lava flow. Did you know that for the second cast you need to open the lava valve again? Only then will there be sufficient heat.

Well i went back to an earlier save, got the second mithril ore. Everything worked fine.

Thanks again for all the help...

I have encountered this twice now. Once entering turn-based mode resolved it, the second occurrence switching to another toon in the party allowed me to reset it.